MA66 Two Zone Mixer/Amplifier 20W/per Zone
This product has been discontinued
- Description
- Specifications
The MA66 is a 2 Zone mixer with a 20 watt per Zone power amplifier built in. The amp section is class D design so it does not generate any heat to the chassis, it can be used in any application. Including Phantom power, talk over that is zone assignable, and an assignable release time for the talk over circuit. With six inputs (2 mic/line XLR and 4 RCA) and an 1/8†jack on the front panel the MA66 has plenty of input capability to satisfy almost any installation. The output section of the MA66 has 20 watts per Zone (40 watts total) that is all class D design. The MA66 also features RCA main outputs. We have also included a remote pad for both zones so you can run an external pad control to any location. The MA66 is easy for anyone to use from the front, but from the rear it is just complex enough it will fill even the most demanding installation requirements. With the included external power supply the MA66 has just about every approval known to man so you can spec it in almost any installation.
- Input Impedance: Mic: 600 Ohms XLR balanced Source: 22K Ohms RCA
- Max Input Level: Mic: -14 dBV Mic level RCA: +24 dBV
- Total - In/Out Connectors: 2: XLR, 6: Stereo RCA, 1: 3.5mm
- Phantom Power: +15 VDC
- RCA Output Level: +17 dBV max (impedance 1K Ohm)
- Output Power: 20 Watts @ 4 Ohms/Per Zone 12 Watts @ 8 Ohms/Per Zone
- Max Gain: Mic: 70 dB Source: 30 dB
- Noise Floor: - 80 dB, THD: <.025%
- S/N Ratio: 96 dB
- Power Output: 20 Watts X 2 (4 Ohms)
- Voltage Gain: 32 dB
- Maximum Supply Voltage: 30 VDC
- THD: .05% typical
- EIN: 3 mV
- Efficiency: 85%
- Bandwidth: 20Hz - 25 kHz
- Size: 19" x 1.75" x 5"
- Two Zone Outputs
- Two XLR Microphone Inputs
- Individual switchable phantom power
- Four RCA and one front panel 3.5mm stereo inputs
- RCA Outputs
- 20 + 20 Watt Power output