PM50sOB EXAMPLE MICROPHONE CONNECTION
Note: Shown here is the PM50sOB - the PM50s operates identically.
• Connect your microphone (dynamic or condenser - the PM50s and PM50sOB pass phantom power) to the Mic Input, and the Mic Thru to the Input on the mixer as shown.
• Connect the Monitor Send from your mixer to the Monitor Input of the PM50s or PM50sOB. If this is a stereo signal, you will again need a 1/4” Tip-Ring-Sleeve plug, and the STEREO/MONO jumper should be in the STEREO position. If the Send from your mixer is mono, use a standard 1/4” Tip-Sleeve cable and place the STEREO/MONO jumper in the MONO position.
• Connect your headphones or earphones as shown.
• Connect the PS27 power supply to an AC outlet, begin playing your keyboard and check the microphone while adjusting each level of the PM50s or PM50sOB for a comfortable volume.