PM350b Connect to a Stereo Guitar Processor
• Connect your microphone (dynamic or condenser - the PM350b passes phantom power) to the Mic Input, and the Mic Thru to the Input on the mixer as shown.
• Connect your guitar to your guitar processor and connect the stereo Output of your guitar processor to the Instrument Input on the PM350b. You’ll need a Tip Ring Sleeve Insert cable (shown in the owners manual) to connect a Right and Left 1/4” Output of the guitar processor to the Instrument Input. Connect two 1/4” balanced or unbalanced (TRS or TS) cables from the Instrument Outputs to your mixer.
• Connect the Monitor Send from your mixer to the Monitor Input of the PM350b. If this is a stereo signal, you will again need a 1/4” Tip-Ring-Sleeve plug, and the STEREO/MONO jumper should be in the STEREO position. If the Send from your mixer is mono, use a standard 1/4” Tip-Sleeve cable and place the STEREO/MONO jumper in the MONO position.
• Connect your headphones or earphones as shown.
• Make sure your guitar processor is on, then connect the PS27 power supply to an AC outlet, begin playing your guitar and check the microphone while adjusting each level of the PM350b for a comfortable volume.